USB Cable Drop Test

Thu Sep 29 14:36:57 CST 2022

USB-Cable-Drop-Test-Quality

USB Cable Drop Test

Purpose of Drop Testing

Simulate the situation of the cables drop from a high location to the ground to verify the appearance and performance of the product.

Drop Testing is applicable to the following products:

USB cable, HDMI cable, RCA connector, audio cable, RJ45 ethernet cable and other cables.

Drop Testing Method :

1. Test the Electrical performance of the sample before this test. Ensure the result is good.

2. Test the Electrical performance of the sample after this test to check the changes.

Testing equipment :

Ruler

Test preparation:

1. Prepare the product: Prepare the cables and make conduction test to confirm them with good conduction for the samples to be tested.

2. Tie the product with tie ties.

3. Mark the product on 6 sides: up/down, left/right, front and back sides.

4. Conduct the test in normal temperature environment.

1_prepare-the-USB-Cable-for-Drop-Test

Test operation steps :

1. Hold the tied cable by hand to 1.2m from the ground, let 1# side face up and keep the product stationary.

2. Release the cable and let the cable fall freely to the marble floor.

3. Repeat step1 and step2 for the second test.

4. With the same method, let the remaining 5 sides face up respectively and perform 2 tests each.

USB-Cable-Drop-Test-HornmicLink

Test Result Determination :

1. No mechanical separation, the appearance should not be damaged

2. The cable is with good conductivity after the test, and can transmit data normally.


For more USB cable performance test items, please refer to this : USB Cable Testing Basic Inspections And Procedures.



HornmicLink Logo-Intelligent Connection Solutions-China USB Cable provider,Charging Cable,Hub Adapter,USB Charger manufacture

By HornmicLink_Henry @220929 14:46