USB Cable Swing Test

Wed Sep 28 17:03:40 CST 2022

USB-Cable-Swing-Testing-HornmicLink

USB Cable Swing Test

Purpose of Swing Testing

Verify Cable's ability to withstand continuous bending to ensure it meets standard quality requirements and customer requirements.

Swing Testing is applicable to the following products:

USB cable, HDMI cable, RCA connector, audio cable, RJ45 ethernet cable and other cables.

Swing Testing Method :

1. Test the Electrical performance of the sample before this test. Ensure the result is good.

2. Test the Electrical performance of the sample after this test to check the changes.

Testing equipment :

Swing Tester

USB-Cable-Swing-Tester-HornmicLink

Test preparation:

1. Prepare the product: Prepare 5 cables and Make conduction test to confirm them with good conduction for the samples to be tested.

2. Conduct the test in normal temperature environment.

Test operation steps :

1. Fix the connectors of all 5 cables, hang a 300g weight at 30cm away from the fix point, then swing at angle of ±60° and a frequency of 30 times/min.

2. Set the total cycle as 5000 times and zeroing out the actual swing counter.

3. Press start button to start testing.

4. Check the cables after finishing target cycle times.

5. In the same way, 5000 cycles were performed on the other connectors.

USB-Cable-Swing-Testing-angle-weight

Test Result Determination :

1. No mechanical separation, the appearance should not be damaged

2. The cable can be powered or charged normally after the test, and can transmit data normally.


For more USB cable performance test items, please refer to this : USB-Cable-Testing-Basic-Inspections-And-Procedures

HornmicLink Logo-Intelligent Connection Solutions-China USB Cable provider,Charging Cable,Hub Adapter,USB Charger manufacture

By HornmicLink_Henry @220928 15:08